Bewertung der VoruntersuchungenDie

Bewertung der Voruntersuchungen
Die Vorversuche haben folgende Erkenntnisse erbracht:
1.) Die Temperaturbeständigkeit des Plattenmaterials, des Lötmittels, der Mantelheizleiter und der elektrischen Isolation wurde bis 1030 °C bestätigt;
2.) Die Temperaturverteilung an der Oberfläche einer einzelnen Platte ist aufgrund der Verlegungsbedingungen für die Heizleiter (mindestens erforderlicher Biegeradius) und der Wärmeverluste prinzipiell inhomogen. Als Schlussfolgerung wird die seitliche Schutzplatte in 2 Heizkreise mit einer besonderen Berücksichtigung der Eckbereiche geteilt, und die seitlichen Wärmeverluste werden durch Anbringung eines dreigeteilten, differenziert regelbaren Heizrings (HR) weiter reduziert;
3.) Optimierung der Löttechnologie zur bestmöglichen Kontaktierug des Heizleiters in den Nuten der Heizplatte

結果 (英文) 1:

Review of the preliminary investigationsThe preliminary tests have yielded the following findings:1.) the heat resistance of plate material, means of solder, the mantle heat conductors and electrical insulation up to 1030 ° C confirmed;2.) the temperature distribution on the surface of a single plate is inhomogeneous in principle due to the laying conditions for the heating cable (minimum required bending radius) and heat loss. In conclusion, the side plate is divided into 2 heating circuits with a special attention to the corners, and the lateral heat losses are further reduced by fitting a divided into three separately adjustable heating ring (HR);3.) optimization of brazing technology to the best Kontaktierug of the heating element in the grooves of the hotplate

結果 (英文) 2:

Review of Preliminary
The preliminary tests have yielded the following findings:
1) The temperature resistance of the plate material, the solder, the jacket heating and electrical insulation was confirmed to 1030 ° C;
2.) The temperature distribution on the surface of a single plate is due to the installation conditions the heating conductors (minimum required bending radius) and the heat losses inhomogeneous principle. In conclusion, the lateral protective plate in 2 heating circuits is shared with a special consideration of the corner, and the lateral heat loss by installing a three-part, differentiated controllable heating ring (HR) further reduced;
3) optimizing the soldering technology to best Kontaktierug the heating conductor in the slots the heating plate

結果 (英文) 3:

evaluation studiesthe preliminary tests have the following results:1) the temperature stability of the plattenmaterials, lötmittels, mantelheizleiter and electrical isolation to 1030) was confirmed;2.) the temperature distribution on the surface of each plate is due to the verlegungsbedingungen for heizleiter (at least in principle, the required bending radius) and heat stability. as a conclusion, the lateral shield in two heating with special consideration of the eckbereiche divided, and the lateral heat loss by installing a three differentiated adjustable heizrings (hr) further reduced;3) optimization of the löttechnologie best kontaktierug of heizleiters in the grooves of the hot plate