danke nochmals für das kurzes Gespr

danke nochmals für das kurzes Gespräch heute Morgen.

Wir haben, zwischen der Zierleiste und der RWT-HL, der Messpunkt diskutiert aber ich habe noch ein Punkt vergessen. Schaust du meine untere Email bitte an. Da steht das was ich vorher zum Christian geschickt habe.

Dafür kommt meine Frage: Könnten wir die 2 Punkte (Schnitt RY385 L/R und Schnitt RY340 L/R) in dem 3D-Messungsplan der Lieferant hinzufügen?

結果 (英文) 1:

Thanks again for the short interview this morning.We have between the moulding and the RWT-HL, discussed the measurement point but I forgot another point. You look at my lower email please. Here is what I previously sent to the Christian.This is my question comes in: we could add the 2 points (cutting RY385 L/R and cut RY340 L/R) in the 3D-Messungsplan to the supplier?

結果 (英文) 2:

thanks again for the short conversation this morning.

We have discussed between the trim and the RWT-HL, the measuring point but I forgot one point. Please Do you watch my lower email. It says what I have previously sent to Christian.

He is replaced by my question: Could we the 2 points (average RY385 L / R and cut RY340 L / R) Add in the 3D measurement plan, the supplier?

結果 (英文) 3:

thank you again for the brief conversation this morning.we have between the trim on the rwt hl, the breakpoints are discussed, but i've got a point. are you looking at my bottom email please. it says that what i had previously sent to christian.this is my question: could we have the 2 points (average ry385 l / r and cut ry340 l / r) in the 3d of a measurement plan of supplier to add?