Verdichtermutter mittels Pinsel und

Verdichtermutter mittels Pinsel und Reinigungsmittel (z.B. Aceton/Nitroverdünnung) entfetten.Gasschieber auf Leerlauf zurücknehmen und warten bis die grüne „OK“ - LED erleuchtet, um anzuzeigen, dass nun die Leistungskontrolle an den Piloten übergeben wurde.Antenne vom Modell entfernen.Befestigen Sie die ECU nicht direkt am Rumpf des Modells sondern auf einem Sperrholzträger mit einer Lage Schaumstoff und Klettverschluss.Überprüfen der Funktion im RC- Check Menu. Neueinlernen der R/C Anlage.Siehe Seite 22

結果 (英文) 1:

Compressor nut by means of brushes and cleaning agents (eg acetone / nitro dilution) degrease.

Reduce throttle slider to idle and wait until the green "OK" - LED illuminated to indicate that now the power control was handed over to the pilot.

Antenna remove from the model.

Do not fix the ECU directly to the hull of the model but on a plywood support with a layer of foam and Velcro.

Check the function in the RC check menu. Neueinlernen the R / C system.
See page 22

結果 (英文) 2:

Degrease the compressor nut by means of brushes and detergents (e.g. acetone/nitro dilution).

Return the throttle valve to idle and wait until the green "OK" LED is illuminated to indicate that the power control has now been handed over to the pilot.

Remove the antenna from the model.

Do not attach the ECU directly to the fuselage of the model, but on a plywood carrier with a layer of foam and Velcro fastener.

Check the function in the RC-Check Menu. New learning of the R/C system.
See page 22

結果 (英文) 3:

Dispose of the condenser by brush and cleaning agent (e.g. acetone/nitrogen dilution).
Withdraw gas sliders to idle mode and wait for the green "OK" LED to illuminate to indicate that the performance control has now been passed on to the pilots.
Remove antenna from model.
Do not attach the ECU directly to the torso of the model but to a plywood holder with a layer of foam and Velcro closure.
Check the function in the RC-Check menu. New learning of the R/C system.
See page 22